Majic 8-0750-3 Paint Reducer, 1 Pint

Specially formulated with non-regulated VOC to provide the perfect spray consistency when added to Majic Tractor & Implement Enamel or Majic Rust Kill Enamel without compromising the VOC limits of these products. 

Highlights:-

• Provides perfect spray consistency
• Does not compromise VOC limits
• Color: Clear
• Size: Pint

Product Statistics:-

• Vehicle: N/A
• Solvent: N/A Water
• Finish: N/A
• Dry Time: Touch: N/A
• Recoat: N/A

Film Thickness:-

• Wet: N/A
• Dry: N/A
• Coverage: N/A
• Viscosity:N/A
• Flash Point: -4° F
• Max VOC: Exempt VOC Formula

Surface Preparaton:-

All surfaces, new or previously painted, must be clean, dry and free of dust, dirt, grease or mildew. Remove loose, scaling paint by wire brushing, scraping or sanding. Glossy surfaces and all protected areas not exposed to normal weathering should be dulled by sanding. Remove oil residues from new metal surfaces by cleaning with rags saturated in mineral spirits. Surfaces with extensive rust or heavy oxidation should be cleaned to remove loose scale, dust and debris.

Warning:-

If you scrape, sand, or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH approved respirator to control lead exposure. Clean up carefully with a HEPA vacuum and a wet mop.

Application:-

Add one pint of Majic Reducer to one gallon of Majic Tractor & Implement Enamel or Majic Rust Kill Enamel. Stir thoroughly. Use an airless sprayer with a minimum pressure of 2000 PSI with a 60 mesh filter, and tip size of .013 -.017. Conventional spray application may require two pints of Majic Reducer for 40-50 PSI. Check tip for wear after spraying 50 gallons and replace if necessary.